Be absolutely sure that you double-click the correct MAC ID in the request history list. Thirdly, boot up your module, and you should see the MAC ID in the “Request History” list.ĭouble-click your module’s MAC ID. If you are unsure of this, check with your system administrator.īe sure your computer is on the same network as the module you are wanting to assign. Normally, this is all the information that you will need to enter. The Subnet Mask is usually going to be 255.255.255.0.
Secondly, you may get a message asking for some network information.
#Remote utilities server ip address software
This is under Start | All Programs | Rockwell Software | BootP/DHCP Server This is also called an “Ethernet Address” or a “Hardware Address” You will usually find this information on a sticker that is on the side of a module. Running the BootP-DHCP Serverįirst, we need to write down the MAC (Media Access Code) of the module.
#Remote utilities server ip address drivers
This will help avoid confusion, and makes configuring drivers for devices much easier. It’s also a good idea to keep a record of all of your system’s IP addresses on a spreadsheet. Here, you may find the IP address that the new module needs to use. If the module is totally dead, open the project in Studio 5000, and locate the module in the I/O configuration tree. When you are replacing a ControlLogix ethernet module (such as the 1756-ENBT or 1756-EN2T), the IP address may be scrolling across the front of the module. If a module does not have the expected IP address, the results could be disastrous. The processor (and other automation equipment) is usually configured to look at certain IP addresses. If you are a troubleshooter, or replacing the module, please don’t guess at what the IP address needs to be. If you are a system designer, you can use an IP address according to the plant standards.
Proportional Settings for ControlLogix PID Enhanced (PIDE).Proportional, Integral, Derivative (PID).
0 kommentar(er)
